Master/Slave Fixture Linking; Mounting; Orientation; Rigging - Chauvet Elan User Manual

Master/Slave Fixture Linking
1. Connect the (male) 3 pin connecto
of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect
O ften, the setup for master-slave and
St and alone operation requires that
th e first fixture in the chain be
initialized for this purpose via either
settings in the control panel or DIP-

Mounting

switches. Secondarily, the fixtures
that follow may also require a slave
setting. Please consult the
"Operating Instructions" section in
this manual for complete instructions
for this type of setup and
configuration.

ORIENTATION

This fixture ma

RIGGING

It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a s
loosening both knobs and tilting the fixture. After finding the desired
position, retighten both knobs.
•
When selecting installation location, take into consideration lamp repl
access and routine maintenance.
•
Safety cables must always be use
•
Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
Élan Manual
r side of the DMX cable to the output (female) 3 pin connector
from the output as stated above to the input of the following fixture and so on.
y be mounted in any position provided there is adequate room for ventilation.
uitable "C" or "O" type clamp. Adjust the angle of the fixture
d.
9
Hanging Clamp
by
acement
Note!
Clamp is sold separatel y.
2007-07-18/11:37