Operation; Stand-Alone Mode (Sound-Active); Master/Slave Mode (Master Sound, Master Auto) - Chauvet Elan User Manual

4. OPERATION

Stand-Alone Mode (Sound-Active):

This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto
Mode.
1) Set dipswitches position to Sound Active Mode.
Mode
Sound Active
Sound Active w/ Strobe
Fixed Speed strobe w/ movement
Strobe w/ Color Change
Sound Activated (no sound for 3 sec. unit will change color rotation)
2) The unit will react to the low frequencies of music via the internal microphone in Sound Active
mode.
3) Use the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
Sound-Active mode. Turning the knob counterclockwise decreases the sensitivity; turning the
knob clockwise increases the sensitivity.
Master/Slave Mode (Master Sound):
This mode will allow you to link up to 32 units together without a controller.
1) Use standard DMX cables to daisy chain your units together via the DMX connector on the side
of the units. For longer cable runs we suggest a terminator at the last fixture.
2) Choose a unit to function as the Master. Turn dipswitches to the Master position on the unit. The
unit must be the first unit in line, and then simply chain the units together using DMX cable.
3) Turn dipswitch 1 to the "on" position on the slave units, and the slave units will react the same as
the master.
Mode
Master Sound
Fixed Speed Strobe with Color Change
Strobe with Color Change Effect
Sound Activated (no sound for 3 sec. unit will change color rotation
Élan Manual 10
Dipswitches
All Off
9, 12 On
9, 10, 11 On
9, 11 On
9, 10, 12 On
Dipswitches
9 On
9, 10, 11 On
9,11 On
9, 10, 12 On
2007-07-18/11:37