Installing The System Board - Dell Vostro 5890 Service Manual

Steps
1. Lay the computer on the right side.
2. Remove the single (6-32) screw that secures the ports bezel to the chassis.
3. Disconnect and un-route all the cables connected to the system board.
4. Remove the eight screws (6-32) and that secure the system board to the chassis.
5. Remove the single (M2x4) screw and that secures the system board to the chassis.
6. Lift the system board at an angle to release the ports and remove the system board off the chassis.

Installing the system board

Prerequisites
About this task
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
46 Disassembly and reassembly