Table of Contents
Advertisement
S
ETUP
Lamp
You may need to install the lamps prior to the initial operation of the fixture. Five JCD 200W halogen
lamps are included.
Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to
cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
L AM P I N ST ALL AT I O N
1)
Remove the (S1) screws located
surrounding the midline of the spheres as
shown in the image.
2)
Pull the top cover out exposing the lamp and
socket. (not shown)
3)
If replacing the lamp, remove old lamp first.
4)
Using a cloth or napkin hold the bulb and
pull out of the lamp socket located inside the
reflector.
5)
Replace with a new lamp.
6)
Replace top cover, align the screw holes
and fasten the screws.
Mounting
O RI E NT AT IO N
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIG G ING
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable "C" or "O"
type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding
the desired position, retighten both knobs.
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
Safety cables should always be used.
Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
CH-540 User Manual
EXTREMELY HOT!
Top Cover
S1
Additional screw on the back side not shown
5
WARNING!
Allow time to cool
before handling
Hanging Clamp
2006-05-05/00:04
Advertisement
Table of Contents
