Firmware Upgrading - Philips DVDR3450H Service Instruction

EN 6 3. 3139 785 3229x
3.

Firmware Upgrading

3.1 Firmware Upgrading
A. Preparation to upgrade fi rmware:
1. Unzip the zip-archive fi le
2. Start the CD Burning software and create a new CD project (data disc) with the following settings:
File system
Format
Recording mode : SINGLE SESSION (TRACK-AT-ONCE), FINALIZED CD
Note: Long fi le name is necessary for the preparation of the upgrade disc
3. Place the content of the zip-archive into the root directory of the new CD project.
4. Burn the data onto blank CDR or CD-RW.
B. Procedure to apply the fi rmware upgrade:
1. Open the tray and load the Upgrade CDROM .
2. The tray closes and set will display:
"FLASH 1"
3. The OSD will display
"Disc Upgrade"
"Software Upgrade Disc detected . Select OK to start upgrading or CANCEL to exit."
4. Click on the <OK> button .
5. The OSD will display:
"Starting Software Upgrade.Please Wait."
with the set display
"VERIFY.. WRITE...DONE"
Then the OSD will display
"Disc Upgrading . Please Wait . Do not switch off the power . "
It will do the Upgrade for the Software and OSD will show .
"Loader Software Upgrade"
and the set will show
"VERIFY"
"Loader Software Upgrade"
"Upgrading Software. Please Wait. Do not switch off the power."
and the set will show
"WRITE"
The whole process takes less than 6 minutes
Note: Do not press any buttons or interrupt the mains supply during the upgrading process,
otherwise the set may becomes defective.
6. When the upgrade is completed the tray will open automatically and the set will display:
"Loader upgrade process has completed successfully. Press [OK] to reboot system."
7. The tray open and the set will display:
"DONE"
8. Press <OK> and the tray close and the set goes to standby.
*Note: 1) The content of the HDD(i.e. the video recording(s) and/or mp3 fi le(s)) will not be erased during the fi rmware
upgrading process.
Firmware Upgrading
: Joliet
: MODE 2: CDROM XA