Firmware Upgrading - Philips DVDR3400/31 Service Manual

EN 6 3139 785 3219x
3.
3.

Firmware Upgrading

A. Preparation to upgrade firmware:
1. Unzip the zip-archive file
2. Copy the files into different folder for burning into CD-R/CDRW.
3. Start the CD Burning software and create a new CD project (data disc) with the following settings:
File system
Format
Recording mode : SINGLE SESSION (TRACK-AT-ONCE), FINALIZED CD
Note: Long file name is necessary for the preparation of the upgrade disc
4. Place the file into the root directory of the new CD project.
5. Burn the data onto blank CDR or CD-RW.
B. Procedure to apply the software upgrade:
1. Open the tray and load the Upgrade CDROM with Software upgrade file.
2. The tray closes and set will display:
"Upgrading SW"
3. The OSD will display
"Software Upgrade Disc detected . Select OK to start upgrading or CANCEL to exit ."
4. Click on the OK button.
5. The set will display:
" Upgrading SW "
and the OSD will display
"Upgrading Software . Please Wait . Do not switch off the power."
The whole process takes less than 5 minutes
Note: Do not press any buttons or interrupt the mains supply during the upgrading process, otherwise the set may becomes
defective.
6. When the upgrade is completed the tray will open automatically and the set will display:
"System software has been successfully upgraded. Press OK to continue with Loader System upgrade."
7. The set will display:
"SW DONE"
Pressing OK and the set will display.
"DRV UPG"
8. The OSD will display
" Loader Software Upgrade – Software Upgrade Disc detected . Select OK to start upgrading or CANCEL to exit. "
9. Click on the OK button.
Firmware Upgrading
: Joliet
: MODE 2: CDROM XA