Spin Drying - Whirlpool LSP880GP Service Manual

TROUBLE
Drain takes time too
long.
Note: In draining, the water level sensor can Note: In draining, the water lever sensor can
not reset in 8 minutes. not reset in 8minutes.
The number window LED display The number window LED display
abnormal code: abnormal code:
on and off at the same time and the on and off at the same time and the
electric buzzer sounds to indicate a electric buzzer sounds to indicate a
problem. problem.
• If the Drain Hose is too long or high, it may
make draining impossible.
• The extend Drain Hose to a maximum long of
3 meters and maximum high of 10 centimeters.
e. Spin Drying
Spin drying cycle
does not work.
Note:
1. The safety switch works 3 times
continuously or works 1 time in the
single program
number window LED display abnormal
code: and begin blinking on and off
at the same time and the electric buzzer
sounds to indicate a problem.
2. Do not disconnect the wire from the
capacitor, because
de-pressing noise from outside to the
micro-computer.
INSPECTION INSPECTION INSPECTION
and begin blinking and begin blinking
Yes
Does safety
device work?
No
.
of spin-dry The
this wire acts as
CAUSES
'
Drain hose ass y is deformed.
Hose is connected in the
wrong way.
Hose is too long or position of
hose is too high.
Machine inclines.
The V-belt is slipping.
The V-belt is snapped.
Small pulley mounting
screw is loosed.
Motor is disconnected or
burnt.
Capacitor is broken or
disconnected.
'
Bearing ass y is defective.
Torque motor is defective.
Brake lever is defective.
Thermostat on motor is
opened.
Poor contact of 6-pin
connectors (blue &white).
Control circuit board is
defective.
6
REMEDY
Repair or replace.
Repair.
Repair.
Replace with level.
Adjust the motor
position.
Replace.
Tighten up.
Replace.
Replace.
Replace.
Replace.
Repair or replace.
Repair or replace
after cooling down.
Repair or replace.
Replace.