IBM ThinkPad 340 Series Hardware Maintenance Manual page 258

▌2▐ When removing the LCD cables, pull the connector
straight up. Incorrect handling can damage the
connector.
Note: For the color model, make sure the indicator
does not hook the most right LCD connector
when replacing the status indicator.
▌3▐ Remove the screw.
▌4▐ Remove the right hinge cover.
▌5▐ When removing the left hinge cover, use a small
screwdriver as shown to release the latch from the
rear base cover. Pull the hinge cover slightly upward
to keep it unlatched.
▌6▐ From the front side, remove the latch with a small
screwdriver as shown to remove the cover. Be
careful not to scratch the surface of the computer
when you use a screwdriver to remove the
latches.
▌7▐ Remove the four screws.
Use the following table for reference when replacing parts.
Step Location (Quantity)
▌1▐
LCD ground-terminal (1)
▌3▐
LCD hinge cover, right (1)
▌7▐
LCD hinge (4)
Note: Make sure you use the correct screw.
Safety Notice 5: Translation on page 11
If the LCD breaks and the fluid from inside the LCD
gets into your eyes or on your hands, immediately
wash the affected areas with water for at least 15
minutes. Seek medical care if any symptoms from the
fluid are present after washing.
Caring for the LCD
When cleaning of the LCD becomes necessary,
gently wipe the LCD with a dry, soft cloth. Do
not use alcohol or detergent to clean the LCD.
To avoid damage to the LCD, do not scratch or
apply any force to its surface.
Do not put anything on the surface of the LCD.
248
IBM Mobile Systems HMM
Length
4 mm
4 mm
4 mm