For United Kingdom Only - Melissa 651-046 Manual

Mini oven with rotisserie
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 22
1. Screw one fork onto the Rotisserie stick.
2. Fork the food to be toasted.
3. Screw the other fork onto the Rotisserie stick. The
Rotisserie forks with food is shown as follows:
4. Install the arrow end of the Rotisserie Forks to the
right rotisserie hole, and then the square end to the
left Rotisserie tray.
5. Use Rotisserie Handle to take out the square end of
the Rotisserie Forks from left the Rotisserie tray, and
then remove the arrow end from the right Rotisserie
hole.
CAUTION: Beware of HOT dripping oil!
CLEANING
When cleaning the appliance, you should pay attention
to the following points:
• Remove plug from the mains socket, and allow the
appliance to cool down before cleaning it.
• Never submerge the appliance in water and make
sure no water enters the appliance.
• Clean the appliance by wiping it with a damp cloth.
A little detergent can be added if the appliance is
heavily soiled.
• Never use a scouring pad or any form of strong
solvent or abrasive cleaning agent to clean the
appliance, as those may damage the inside and
outside surfaces of the appliance.
• Make sure that no water gets into the vent holes.
• The baking tray and the grid can be washed in warm
water and washing-up liquid.

FOR UNITED KINGDOM ONLY

Plug wiring:
This product is fitted with a BS 1363 13-amp plug. If
you have to replace the fuse, only those that are ASTA
or BSI approved to BS1362 and with a rated current
of 13 amps should be used. If there is a fuse cover
fitted, this cover must be refitted after changing the
fuse. If the fuse cover is lost or damaged, the plug must
not be used. You must also check if the socket outlets
in your home fit with the plug of the appliance. If the
socket outlet in your home does not fit with the plug,
the plug must be removed and disposed of safely as
insertion of the plug into the socket is likely to cause
electric hazard. A replacement plug should be wired
according to following description.
Important
This appliance must be earthed. The wires in the cord
set are coloured thus:
BLUE- Neutral, Brown-Live, Green& Yellow-earth
(For detachable plug only)
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as follows:
The wire that is coloured Green& Yellow must be
connected to the terminal in the plug that is marked
with the letter E or by the earth symbol, or coloured
green& yellow.
The wire that is coloured blue must be connected to
the terminal that is marked with the letter N or coloured
black.
The wire that is couloured brown must be connected to
the terminal that is marked with the letter L or coloured
red.
25

Advertisement

Table of Contents
loading

Table of Contents