Maintenance; General; Daily Cleaning; Replacing A Display Light - Hatco GLOMAX GM5AH Series Installation And Operating Manual

MAINTENANCE

General

GLOMAX Curved Infrared Strip Heaters are designed for
®
maximum durability and performance with minimum maintenance.
ELECTRIC SHOCK HAZARD:
• Turn OFF power switch, turn off power at circuit breaker,
and allow unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not steam clean or use excessive water on unit.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some after-market or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
+1-414-671-6350.
Use only Hatco-approved LED light assemblies that are
designed specifically for food holding areas. Using LED
light assemblies not designed for food holding areas could
result in personal injury and/or food contamination.
WARNING

Daily Cleaning

To preserve the finish of the unit, it is recommended that all
surfaces be cleaned daily.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch the finish of the unit,
marring its appearance and making it susceptible to soil
accumulation.
1. Turn off the unit and allow the unit to cool.
2. Wipe down all metal surfaces with a water-dampened,
non-abrasive cloth. Stubborn stains may be removed with
a good stainless steel or non-abrasive cleaner. Clean hard
to reach areas using a small brush and mild soap.
3. Wipe dry the entire unit using a non-abrasive, dry cloth.
Replacing a Display Light—GM5AHL Series
The display lights consist of two LED light channels that
illuminate the warming area. These light channels have special
covers to guard against injury and food contamination in the
event of breakage.
Replacement of a LED light channel must be done by an
Authorized Hatco Service Agent.
NOTE: Hatco LED light channels meet safety standards for
food holding and display areas.
10
NOTICE
Form No. GM5AHCEM-0619