Behringer Pro-1 Documentation And Instructions page 21

Behringer Pro-1 Ctrlr panel documentation and instructions v2.0
Patch points
Besides drawing the patch cables directly on the front panel, you can also modify the from/to
patches as follows:
Clicking anywhere on a patch line (label, input, output, blank space) will select the patch to be
modified and display its values in the pull-downs. You modify the "From" source and/or "To"
destination and press the Proceed button to make the change.
You can also directly select a patch cable in the Patch pull-down then modify the From/To and press
Proceed.
Use the Unpatch button to delete a patch cable or the Unpatch All button to delete all of them at
once.
Use the Cables button to switch the display on the main panel between patch cables and just cable
plugs. This button will be locked on Cables display as soon as the same input or ouput is used two
times.
Patches are numbered 1 to 9 and have a color assigned to them. When a from/to patch is set in the
Envelopes and Patches tab, corresponding patch cables are displayed on the main Pro-1 tab and
corresponding colored numbered circles are displayed on the patch sheet.
Numbered circles are used to help colorblind people.
Available "From" sources are the output patch points of the synthesizer plus a few additional
external ones: "Not connected", "LFO CV Out", "Keyboard CV Out", "Gate Out", "Mixer Out", "Filter
sunny.synths@gmail.com Page 21 of 49