Casio E-CON2 Use Manual page 5

7. Use number keys b through f to specify the unit for the value you specified in step 5.
• When you select a unit, the Final Setup Wizard screen appears on the display.
8. Press number keys described below to specify what you want to do with the setup you
have configured.
b(Start Setup) ................ Starts sampling using the setup (page 8-1)
c(Save Setup-MEM) ...... Saves the setup (page 6-2)
d(Convert Program) ....... Converts the setup to a program (page 7-1)
k Using Setup Wizard to Configure a PhotoGate Setup
Connection of a Vernier PhotoGate requires configuration of setup parameters that are
slightly different from parameters for other types of sensors.
To configure a setup for PhotoGate alone
u u u u u
1. Perform the first three steps of the procedure under "To configure an EA-200 setup using
Setup Wizard" on page 2-2.
2. On the "Select Sensor" screen, select [VERN] - [P-Gate] - [None].
• This causes a "Gate Status" screen to appear.
• "Open" means the photo path is not blocked, while "Close" means the photo path is
blocked.
• The gate status defines what PhotoGate status should cause timing to start, and what
status should cause timing to stop.
Open-Open ...... Timing starts when the gate opens, and continues until it closes and
Open-Close ...... Timing starts when the gate opens, and continues until it closes.
Close-Open ...... Timing starts when the gate closes, and continues until it opens and
Close-Close ...... Timing starts when the gate closes, and continues until it opens and
2-3
Using the Setup Wizard
then opens again.
then opens again.
then closes again.
20021201
Final Setup Wizard Screen