Casio E-CON Software Manual page 16

u To use the MULTIMETER Mode
You can use the Channel parameter settings of Advanced Setup to configure a channel so
that EA-100 MULTIMETER Mode sampling is triggered by a calculator operation.
1. Use the Channel parameter setting Sensor item to configure a sensor.
• See "To create an EA-100 setup using Advanced Setup" on page 2-4 for more
information.
2. After making the required settings, display the Advanced Setup menu and then press 2
(MULT).
• This displays the channel selection screen for MULTIMETER Mode sampling.
3. Specify a channel for sampling.
• Pressing a function key to specify a channel causes the EA-100 to enter the
MULTIMETER Mode and start sampling over the specified channel.
4. To stop MULTIMETER Mode sampling, first press the A key. After the Break screen
appears, press i.
• Sample data is updated at intervals of 0.52 second.
• Do not have sensors connected to channels other than the one you specify in step 3.
However, it is not necessary to specify "None" for the Channel parameter Sensor item for
the unused channels.
• Sample data is not stored in memory.
2-14
EA-100 Setup