Wiring Instructions - Montigo MAHANA PL42VO Installation & Maintenance Manual

LED Remote Receiver Installation (Optional Accessory)

Wiring Instructions

A qualified electrician must install the remote control system.
Turn off all power and gas to fireplace.
WARNING
This remote control system must be installed exactly as outlined
in these instructions. Read all instructions completely before
attempting installation. Follow instructions carefully during
installation. Any modifications of this remote control or any of its
components will void the warranty and may pose a fire hazard.
Figure 43
Removal of wire nut
1. The remote receiver is installed in the main control box. To start,
remove the wire nut from the wire feeding into the control box.
Figure 45
Attaching the receiver
2. Place a Velcro strip (provided) on the bottom of the control box to
fasten the receiver in place, with the other strip on the bottom of the
receiver. Then place the receiver into the box.
Page 20
Figure 44
Removal of wire nut
Figure 46
Attaching the receiver
Figure 47
Connecting the LED receiver
3. Connect the white power connector from the LED receiver to the
connector from the control box.
Figure 48
4. Connect the wires from the remote receiver to their respective
terminals in the LED receiver (BK-Black R-Red G-Green BL-Blue)
Installation
Wiring the LED receiver
XG0219 - 080421