Service Period; Servicing; Tyre Maintenance; Fitting And Repairing Tyres - Sunrise Medical Quickie Attitude Directions For Use Manual

9.0 Service Period

Servicing:

If you have any questions or require any help, please contact
your authorized Sunrise Medical dealer, who will be pleased to
advise you with regards to servicing and repairs.
Depending on how much you have used your add-on bike, we
recommend that you take it to your dealer at least every 6
months, to have your add-on bike inspected by trained
personnel.

10.0 Tyre Maintenance

The add-on bike is equipped with a 20" drive wheel. Make sure
that they are always at the recom¬mended tyre pressure, as
this will significantly affect the driving characteristics. If the tyre
pressure is too low, movement and manoeuvrability is made
more difficult due to the increased rolling resistance and this
also increases the amount of effort required.
The optimum tyre pressure (usually 3-4 bar) is indicated on
each tyre.

Fitting and repairing tyres:

Before fitting a new inner tube:
• Inspect the base of the rim and he tyre inner wall for foreign
bodies and if necessary clean thoroughly
• Check the condition of the rim tape, particularly at the valve
hole. Only well fitting, strong rim tape offers long-term protection
against inner tube damage through burrs and sharp spoke
heads.

Inflation:

Before inflation check all round on both sides, to make sure that
the inner tube is not trapped between the tyre bead and the rim.
Push the valve back gently and pull it back out, so that the inner
tube achieves an optimum position around the valve.
WARNING!
After fitting, check the tyre pressure. It is essential that you
maintain regulation tyre pressure and keep the tyres in perfect
condition, in order to ensure your personal safety and keep your
add-on bike properly.

11.0 Maitenance Brakes

Maintaining the Brakes:

Check regularly the condition of the brake pads and the brake
disc. After 1,500 km the brake cables should be replaced
completely. The brake pads need to be replaced if the thickness
measured at the thinnest point is 2,5 mm. The distance
between brake-pads and disc needs to be re-adjusted as the
brake-pads wear.
Attitude/Attitude Hybrid Rev.3.0

12.0 Cleaning/Hygene

• The add-on bike should be cleaned regularly and after each
bigger journey with commercially available, household
cleaning agents.
• If needed only use a little water.
• Handles, display and battery may only be cleaned by wiping
with a damp (not wet) cloth.
• The drive wheel can be cleaned with a soft sponge or a soft
brush.
• The docking pins at the wheelchair and the docking system
can be cleaned with water, a soft sponge or a soft brush
(recommended after each ride).
• After cleaning please use a penetrating oil (e.g. Ballisto WD
40, Caramba...) to lubricate the moving parts of the docking.
CAUTION!
• Never use steam or high pressure to clean the product.
• Never use any abrasive cleaning agents or aggressive,
acidic cleaners.
• Make sure that water will not get into contact with the
electrical connectors.

Hygiene when being reused:

When the add-on bike is to be reused, it should be prepared
carefully, and be wiped and treated with spray disinfectant on all
surfaces which could come into contact with the user. If you
need to do this quickly, you must use a liquid, alcohol based
disinfectant suitable for medical products and devices. Please
pay attention to the manufacturer's instructions of the
disinfectant you are using.
21