Additional Information; Installation Procedure - Compaq Smart Array 221 User Manual

Additional Information

Readme files containing the latest information about using Compaq options in a
NetWare environment, including the driver installation procedure, are included
on the Novell SSD diskettes. Locate and read this procedure. If the procedure
differs from that shown here, use the one on the SSD diskette.
To read the Readme files, you need a server with a DOS partition or a PC
running DOS or Windows:
1. Place the Novell SSD diskette in the floppy drive.
2. From the DOS prompt, type:
a:\readme
or
Select Start → Run from Windows, then enter:
a:\readme.com
3. Select the files to read or print. Some files that should be of particular
interest are:
READ1ST.RDM
DRIVERS.RDM
STORAGE.RDM

Installation Procedure

The following steps outline the procedure to install the Smart Array 221
Controller driver for NetWare on your server
1. Boot the server.
2. From the DOS prompt, copy the CPQARRAY.HAM and
CPQARRAY.DDI driver files from the Novell SSD diskette 3
\DRV_ARRY directory to the primary DOS partition on the boot hard
drive in the server. This is where the NetWare server files are located
and is usually drive c:
copy a:\drv_arry\*.* c:\nwserver
Writer: Karen Hale Project: Compaq Smart Array 221 Controller User Guide Comments: 388541-001
File Name: H-CH07.DOC Last Saved On: 11/3/98 9:51 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Smart Array 221 Controller User Guide
7-3