Filling The Water Tank - TEFAL EXPRESS EASY CONTROL Manual

Description
1. Comfort handle
2. Steam control
3. Thermostat light
4. Easycord power lead outlet
5. Iron rest
6. Power cord
7. Power cord storage space
8.
Power Zone button
9. Retaining clip for locking iron on the base unit
10. Water tank filler cover
11. 1,7 L water tank
12. Boiler (in the base unit)
Locking system for retaining the iron on the base - Lock-system
Your steam generator is fitted with a retaining hoop to hold the iron onto the base with a locked position for easy
transport and storage -
• Locking - fig.2
• Unlocking - fig.3.
To transport your steam generator using the handle of the iron:
- Put the iron on the steam generator iron rest and raise the retaining hoop over the iron until it locks into place (audible
click) - fig.2.
- Hold the iron by the handle to transport your steam generator
Preparation
What water may be used?
• Tap water:
Your appliance has been designed to function using untreated tap water. If your water is very hard, we recommend you
use a mix of 50% untreated tap water and 50% distilled water available in hardware stores.
• Types of water not to use:
Heat concentrates the elements contained in water during evaporation. The types of water listed below may contain
organic waste, mineral or chemical elements that can cause spitting, brown staining or premature wear of the
appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries, air conditioners,
rain water, boiled, filtered or bottled water. These types of water should not be used in your TEFAL iron. Also only use
distilled water as advised above.
Always remember:
Never use rainwater or water containing additives (like starch, fragrance or water from domestic appliances). Such
additives can affect the steam properties and at high temperature, form deposits in the steam generator chamber
which are likely to stain your washing.

Filling the water tank

• Put the steam generator on a flat, stable, heat-resistant surface.
• When the red «Water tank empty» light is flashing
• Unplug the steam generator. Open the water tank filler cover
• Fill the water tank using a jug and taking care not to exceed the MAX level
• Close the water tank filler cover
• Plug the steam generator in again. Press the «ON-OFF» restart button
goes out to continue ironing.
Switch the steam generator on
The first time the
appliance is used, there
may be some fumes and
smell but this is not har-
mful. They will not affect
use and will disappear
rapidly.
PLEASE REFER TO SAFETY INSTRUCTIONS AT THE BEGINNING
OF THIS BOOKLET BEFORE USING YOUR APPLIANCE
fig.1:
- fig.7.
• Completely unwind the power cord
- fig.10.
• Plug your steam generator into an earthed socket.
• Press the «ON-OFF» button
• The «ON-OFF» button light and the iron thermostat light remain flashing while the
appliance is warming up. When the light stops flashing (after approximately 2 minutes) the
steam generator is ready.
13.
Steam cord
14. Sliding storage space for steam cord
15. Scale collector cap
16. Scale collector
17. Control panel
a. «Anti-scale» light
b. «Water tank empty» light
c. «OK» button
d. «ON-OFF» button with light
e. «ECO MIN» button with light
18. Ultra Gliss soleplate
- fig.1.
- fig.4, there is no more steam. The water tank is empty.
- fig.5.
- fig.8
- fig.9 and take the steam cord out of its storage space
- fig.8.
76
- fig.6.
under the control panel until the light