12.2 Operation PT1001-A1
A6V11899865_en--_b
Activate the alarm
◈
Press the red <Start Voice Alarm> button.
The alarm is activated.
Reset the alarm manually
◈
Press the black <Reset Voice Alarm> button.
The alarm is reset.
Silence the alarm manually
◈
Press the green <Silence Voice Alarm> button.
The alarm is silenced.
Reset the latching fault message
The 'Fault' LED lights up.
The fault in the system has been rectified.
◈
Press the black <Reset Fault> button.
The 'Fault' LED goes out.
The fault party of system resets.
The fault message is reset.
Recur fault messages
The LED Fault lights up again.
The fault in the system has not been rectified.
1. Inform Siemens customer support.
2. Request that maintenance be carried out by technical personnel.
Silence an active buzzer
The buzzer is active
◈
Press the black <Silence Buzzer / LED Test> button.
The buzzer has been silenced.
The buzzer is activated again on a new event.
Perform a LED test
1. Press and hold the black <Silence Buzzer / LED Test> button for a few
seconds to test the function of the buzzer and the LEDs.
2. If there is no fault displayed, the LED test can be carried out.
System operating unit PT1001-A1
Operation PT1001-A1
12
43 | 54