Getting Started - VTech Myla the Blush and Bloom Unicorn Parents' Manual

GETTING STARTED

How to Exit Try-Me Mode
The Unicorn is in Try-Me mode in the packaging.
Slide the Off/Low/High Volume Switch on the underside of the
unicorn to turn the unit Off and then slide the switch to either Low
Volume or High Volume
BATTERY REMOVAL AND INSTALLATION (Unicorn)
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the underside
of the unit, use a screwdriver to loosen the
screw and then open the battery cover.
3. If used batteries are present, remove these
batteries from the unit by pulling up on one
end of each battery.
4. Install 4 new AA (AM-3/LR6) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries or
fully charged Ni-MH rechargeable batteries
are recommended).
5. Replace the battery cover and tighten the screw to secure.
BATTERY REMOVAL AND INSTALLATION (Magic Wand)
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the side of the
unit, use a screwdriver to loosen the screw
and then open the battery cover.
3. If used batteries are present, remove these
batteries from the unit by pulling up on one
end of each battery.
4. Install 2 new AAA (LR03/AM-4) batteries
following the diagram inside the battery box.
5. Replace the battery cover and tighten the screw to secure.
to turn the unit On again.
4