Table of Contents
Advertisement
MODELS: WT-46809 / WS-55809 / WS-55819 / WS-65809 / WS-65819
F. Toggle Between Reception Modes
Pressing "3" when in the Adjustment Mode toggles between NTSC, HD, 480P and VGA. However data
changes are not automatically saved. Press "ENTER" to save data before pressing "3".
6.
Convergence Adjustment Mode
The Convergence mode is used to perform raster geometry correction, and convergence adjustments.
These adjustments must be made in both the SD (NTSC) and HD modes.
A. Convergence Mode Activation
1.
Press MENU-0-1-5-9
2.
When the Convergence Mode is activated, the display below appears on a Green Crosshatch.
B. Selecting the HD or SD Mode
1.
Select the Signal Source before entering the Convergence Mode, either an NTSC or HD source.
2.
Enter the Convergence Mode
•
If the signal source is NTSC, the SD mode is activated.
•
If the signal source is HD, the HD mode is activated.
3.
Activating the HD mode when no HD signal is available
•
Activate the Factory Option Menu (MENU-0-1-7-0)
•
Use the "Adjust" keys to select "DTV Port" and use the "Enter" key to change the setting from
"AUTO" to "1080i".
•
Exit the Option Menu (Press MENU twice)
• Select the DTV Inputs as the signal source (INPUT button)
•
Activate the Convergence Mode ... the Convergence mode will be in the HD mode and the
internal crosshatch is displayed.
4.
After adjusting Convergence, be sure to set the DTV Port back to AUTO.
•
Select an analog Input as the signal source (INPUT button)
•
Activate the Factory Option Menu (MENU-0-1-7-0)
•
Use the "Adjust" keys to select "DTV Port" and use the "Enter" key to change the setting from "HD"
to "AUTO".
•
Exit the Option Menu (Press MENU twice)
C. Convergence Mode Functions
In the Convergence Mode there are three main Functions (Categories).
•
Pressing "6" activates CONV MISC
•
Pressing "5" activates COARSE CONV
•
Pressing "4" activates FINE CONV
Page 24
Advertisement
Table of Contents
