Table of Contents
Advertisement
Workman Tow Hitch
1. On the side of the tow hitch, slide the jack onto the
jack tube
(Figure
10).
1. Jack stand
2. Rotate the jack stand to align the holes and secure with
the lynch pin
(Figure
4
Positioning the Storage Pins
Parts needed for this procedure:
2
Storage pin
Procedure
The storage pins
(Figure
or rear holes of the core processor.
Front Hole Position
When the storage pins are inserted into the front holes, the
core processor can safely be disconnected and removed from
the tow vehicle
(Figure
11).
Rear Hole Position
After the core processor is connected to the tow vehicle,
insert the storage pins into the rear holes
Important: The core processor can only be operated
when the pins are in the rear position
Figure 10
2. Jack-stand tube
10).
11) are to be inserted into the front
(Figure
11).
1. Storage pin
2. Front hole (core processor
disconnected from tow
vehicle)
5
Mounting the Core Processor
for One-Pass Operation
Parts needed for this procedure:
1
Hitch pin (included with the one-pass hitch)
1
Lynch pin (included with the one-pass hitch)
2
Hitch pin (included with the one-pass hitch)
2
Lynch pin (included with the one-pass hitch)
5
Cable tie
Procedure
Note: The core processor must be equipped with the One
Pass Hitch Kit (Model 09753) before it can be mounted to
the aerator.
1. Make sure that the processor brush is set for correct
height of cut.
2. Using a tie down or rope, secure the tow-arm hitch
plate to the frame hitch pivot while raising the tow-arm
for installation
14
Figure 11
3. Rear hole (core processor
connected to tow vehicle)
(Figure
12).
Advertisement
Table of Contents
