Braun UVL Series Operator's Manual page 44

34585
W ARNING
LIFT OPERATING INSTRUCTIONS
• Read manual before operating lift. TO DEPLOY PLATFORM:
• Load and unload on level surface only.
• Engage vehicle parking brake before 1. Stand clear and press UP switch until
operating lift. platform extends fully. Release switch.
• Provide adequate clearance outside of 2. Lift handrail latch handles, deploy
vehicle to accommodate lift. handrails up to vertical position and
• Do not operate lift if you suspect lift lower latch handles fully.
damage, wear or any abnormal condition. 3. Lift outer barrier to vertical position.
• Keep operator and bystanders clear of 4. Latch handrail belt.
area in which lift operates. 5. Press UP switch until platform stops.
• Handrail latch handles must be down
6. Open bus door fully.
except when stowing and deploying 7. Press UP switch until platform stops
handrails. (raises to floor level), and inner
roll stop unfolds to floor level.
Whenever a wheelchair passenger
is on the platform, the: TO UNLOAD PASSENGER:
• Handrail belt must be latched.
• Passenger must be positioned fully 1. Load passenger onto platform and
inside yellow boundaries lock wheelchair brakes.
• Wheelchair brakes must be locked
2. Press DOWN switch until platform stops.
• Inner roll stop and outer barrier 3. Close bus door fully.
must be up. 4. Press DOWN switch until the entire
Failure to follow these rules may result
platform reaches ground level and
in serious bodily injury and/or property outer barrier unfolds fully.
damage. 5. Unlatch handrail belt, unlock
wheelchair brakes and unload
passenger from platform.
DOT — Public Use Lift
31937
W ARNING
1. Fold outer barrier down.
Before stowing lift:
• Lower outer barrier
Before
down to platform. stowing
• Lower handrails down lift:
(Steps 1-3)
to platform.
• Lower latch handles
down to platform.
After
deploying
Failure to follow these
lift:
precautions may result
(Reverse
in serious bodily injury
procedures)
and/or property damage.
Page 42
Decals and Antiskid
TO LOAD PASSENGER: Read lift operating
1. Load passenger onto platform, lock
instructions before
wheelchair brakes and latch handrail
belt.
operating lift.
2. Press UP switch to fold outer barrier
up and raise platform until platform
stops. Failure to do so
3. Open bus door fully.
4. Press UP switch until platform stops
may result in
(raises to floor level), and inner
roll stop unfolds to floor level.
serious bodily
5. Unlock wheelchair brakes and unload
passenger from platform.
injury and/or
TO STOW PLATFORM:
property damage.
1. Latch handrail belt.
2. Press STOW switch until platform
stops at stow level.
3. Unlatch handrail belt.
4. Fold outer barrier down to platform
(horizontal) position.
5. Lift handrail latch handles, stow
handrails down to platform (horizontal)
position and lower latch handles fully.
6. Press STOW switch until platform
stops (retracts fully).
34585
33602
HANDRAIL INSTRUCTIONS
2. a. Lift latch handle. 3. a. Lift latch handle.
b. Deploy / Stow handrail. b. Deploy / Stow handrail.
c. Lower latch handle. c. Lower latch handle.
Latch Handle Detail b.
a.
c.
Decals
34590
W ARNING
81821
34590
81821
12375
a.
c.
b.
Parking Courtesy
Requested
Latch Handle Detail
"Providing Access to the World"
1-800-THE LIFT
33602
29884
31409
MANUAL OPERATION
OUT (TO EXTEND PLATFORM):
1. Pull T-Handle.
2. Turn T-Handle to lock platform
in released position.
3. Pull platform out.
4. Turn T-Handle.
5. Push T-Handle in.
6. Turn T-Handle to lock platform
in engaged position.
DOWN (TO LOWER PLATFORM):
Using hand pump handle, open
hand pump valve (turn counter-
clockwise). Open 1/2 turn only.
OPEN
DOWN (TO UNFOLD
OUTER BARRIER):
1. Remove hairpin cotter
from detent pin.
2. Remove detent pin.
3. Unfold (rotate) barrier
down.
UP (TO FOLD
OUTER BARRIER):
1. Fold (rotate) barrier up.
2. Insert detent pin.
3. Insert hairpin cotter
in detent pin.
UP (TO RAISE PLATFORM):
Using hand pump handle:
1. Close hand pump valve (turn
clockwise).
2. Insert handle in pump and stroke.
Note: Close valve before
operating electric pump.
IN (TO STOW PLATFORM):
1. Raise or lower platform to stow
level (follow UP or DOWN
procedures).
2. Pull T-Handle.
3. Turn T-Handle to lock platform
in released position.
4. Push platform in.
5. Turn T-Handle.
6. Push T-Handle in.
7. Turn T-Handle to lock platform
in engaged position.
Read operator's manual for further details.
®
DOT — Public Use Lift
www.braunlift.com
12375
W AR
NIN
G
Pus
man h T-ha
and out ually mov ndle in
lock Failu befo to eng e plat fully and
resu re re to driv age plat form
dep plat loym lt in unin lock ing plat vehi form in
resu form ent. tend ed form cle.
and lt in /or dep seri loym Unin tend plat may form
prop ous erty bod ent may ed
Do dam ily inju
not rem age. ry
ove 81823
!
VALVE
CLOSE
W AR
NIN
G
Pus h T-ha
and man ually ndle
lock out mov to in fully
resu Failu re befo re eng age e plat and form
dep lt in to lock driv ing plat form in
plat form loym unin ent. tend plat form vehi cle.
and resu lt in dep Unin ed plat may
/or prop seri loym ous ent tend ed form
Do erty bod dam may ily
not age. inju ry
rem ove 81823
!
31409