Cannot Print Properly From The Digital Camera - Canon PIXMA iP6000D Printing Manual

Cannot Print Properly from the Digital Camera

The following are the possible errors that may occur when printing directly from a
digital still camera or digital video camcorder*, and the countermeasures to eliminate
them.
*Hereafter, the digital still camera and digital video camcorder are collectively called a
digital camera or camera.
Error message on
camera
Printer in use
Printer warming up
No paper
Paper error
Paper jam
Printer cover open
No print head
*2
Waste tank (ink absorber
Ink is low
Ink tank is empty
Printer error
Photos are printed from the computer.
Wait until printing ends. The printer automatically starts printing the photos from the
camera after completing the current printing.
Wait until warm-up ends. When it is ready, the printer starts printing automatically.
Load paper in either the sheet feeder or cassette which you have selected with the
paper feed switch on the printer, and select Continue
The paper output tray is closed. Open it to resume printing. If the inner cover is open,
close it.
Select Stop Stop Stop in the display on your camera to stop printing. Stop
Remove the jammed paper, load new paper, and press the RESUME
printer to resume printing.
Close the cover on the printer.
The POWER lamp on the printer flashes five times.
No print head is installed. Install a print head according to the Quick Start Guide .
When there is a print head installed, the print head is defective.
Contact the Customer Care Center.
) full The waste ink absorber
The printer has a built-in waste ink absorber to hold the ink used during print head
cleaning. This error message indicates that the waste ink absorber is nearly full.
You can continue printing for a while by selecting Continue
camera.
However, because printing is disabled once the waste ink absorber becomes
completely full, you are recommended to contact the Customer Care Center as early as
possible.
It is about time to replace the ink tank with a new one.
Select Continue Continue Continue Continue
Printing resumes once the cover is closed after ink tank replacement.
You can continue printing by selecting Continue
the ink tank empty. But, it is recommended you replace it with a new one immediately
after printing. It may damage the printer if you continue printing with empty ink tanks.
Select Stop Stop in the display on your camera to stop printing.
Stop Stop
Disconnect the cable between the printer and the camera, turn off the printer, and
unplug the power cord of the printer from the power supply. After a while, plug the
power cord of the printer back in, turn on the printer, and then reconnect the camera
to the printer.
If the same error occurs, contact the Customer Care Center.
Try This
*2
is nearly full.
*1
in the display on your camera to resume the printing.
Continue
Continue Continue
*1
Continue in the display on your camera.
Continue Continue
RESUME button on the
RESUME RESUME
*1
Continue in the display on your
Continue Continue
*1
in the display on your camera with
84