Troubleshooting - Jacuzzi J-LXK Installation Manual And Use & Maintenance

Troubleshooting

If the spa is not working the way it should, please first review
all the installation and operating instructions in this manual and
check the message on the panel display. If you are still not sat-
isfied it is working properly, please follow the troubleshoot-
ing instructions provided.
None of the components are working (pump, light)
Is there power to the spa?
Is the household circuit breaker tripped?
I
Call your authorized dealer.
Pump does not operate but light does
I
Press the JETS 1 button:
I
If the water remains still, check the level and make sure the
spa is plugged in. If it does not solve the problem, contact your
authorized dealer.
The main jets pump 1 operates but no water flows to jets.
Jets may all be closed. Verify all jets are in the open "on" po-
sition.
Pump may not be properly primed. This can happen after the
spa is drained and refilled.
I
Press the JETS 1 button on the control panel several times,
never leaving the motor running for more than 5 to 10 seconds
at a time. Turn power off and let the air out of spa plumbing sys-
tem by removing the filter cartridge . Make certain you reinstall
the filter cartridge before turning on spa power and restarting
the jets pump 1.
POOR JET ACTION.
I
Make sure the pump is active.
I
Check the position of the selectors of the type of massage.
I
Open air control
I
Check for proper water level.
I
Check that the filter cartridges are not dirty.
WATER IS TOO HOT.
I
Reduce temperature setting.
WATER IS TOO COLD
I
Check temperature setting.
I
Keep the spa cover in place while heating.
I
If the heater indicator on the display is on but no increase in
temperature is noted after a reasonable period of time contact
your reseller or the authorised assistance centre.
Should checking the above steps fail to correct the problem,
please call an autorized dealer or service center.
36