Multiple Access Points With The Same Name Exist. Is Displayed; The Directly Entered Access Point Was Not Detected. Is Displayed - Canon PIXMA MX870 Network Setup Manual

Multiple access points with the same name exist. is Displayed

Check
The message appears when multiple access points with the
same name are found.
When you have only one access point
Select Use one AccessPoint only, then select the MAC
address of the target access point.
• For subsequent operations, go to
in "Entering the Access Point's Wireless LAN Settings Directly
on the Machine" on page 9.
• For details on how to check the MAC address of the access
point, refer to the manual supplied with the access point or
contact its manufacturer.
When using multiple access points
Select Use multiple AccessPoints.
• For subsequent operations, go to
Wireless LAN Settings Directly on the Machine" on page 9.
Glossary
• MAC address
A unique number assigned to each network device.
or / /
or / / in "Entering the Access Point's

The directly entered access point was not detected. is Displayed

Check
The message appears when no access point is found by
the entered access point name/network name (SSID).
Check 1
Is the entered access point name/network name (SSID)
correct?
Press the OK button to make sure that the entered access
point name/network name (SSID) is correct, then press the
OK button again.
Check 2
Make sure that you follow Check 1, 2, 5 and 6 of "Connection Checklist" on page 12.
• After that, press the OK button, then proceed with the setup from
Point's Wireless LAN Settings Directly on the Machine" on page 9.
Check 3
Turn off the access point, then turn it back on.
After that, press the OK button, then proceed with the setup from
•
Point's Wireless LAN Settings Directly on the Machine" on page 9.
Check 4
Is the MAC address filtering enabled on the access point?
• For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Set the access point to accept the MAC address of the
machine.
• After that, press the OK button, then proceed with the setup from
in "Entering the Access Point's Wireless LAN Settings Directly
on the Machine" on page 9.
• For details on how to change the settings of the access point,
refer to the manual supplied with the access point or contact its
manufacturer.
• To check the MAC address of the machine, press the Setup
button, then using the { } [ ] and OK buttons, select
Device settings > LAN settings > Confirm LAN settings >
WLAN setting list, then check MAC address.
in "Entering the Access
in "Entering the Access