Canon PIXMA MX700 Series Network Setup Manual page 22

3
When the Check Wired LAN Connection
dialog box appears, remove the LAN
connector cap, connect the machine to the
network devices such as hubs with a LAN
cable, then click Yes.
(A) Wired LAN connector
Note
The connection may vary depending on your network
environment.
4
Confirm that the setup program detects the
machine automatically.
The machine connected with the USB cable is
detected automatically via LAN connection.
Note
If the machine was not detected, the Set Printer IP
Address dialog box appears. Make sure of the
following, then click Connect.
The network devices such as hubs or routers are
turned on, and the machine and the computer are
connected to the network.
The machine is connected to the computer with the
USB cable.
The IP address to be set for the machine is
displayed on the Set Printer IP Address dialog
box. If it is different from the address you want to
set for the machine, enter the desired IP address
on the Set Printer IP Address dialog box.
(If the machine is turned off, the Set Printer IP
Address dialog box does not appear.)
If it still fails, see "The Set Printer IP Address dialog
box is displayed during setup" on page 29.
5
When the Setup Completion dialog box
appears, remove the USB cable, then click
OK.
The network connection between the machine and
the computer is now successfully established.
The Printer Setup Utility (Print Center in Mac OS X
v.10.2.8) and Canon IJ Network Scanner Selector
will start up.
22
(A)