Install The Ink Tanks; Align The Printhead - Canon MultiPASS MP700 Setup Sheet

Install the ink tanks.

1
Start with the yellow ink tank. Pull the orange tape in the direction of the arrow
and remove the plastic wrapper so you can see the air hole A. Turn the ink tank
over so that the protective cap B is facing up. Then hold the ink tank as shown
below and remove the protective cap B.
A
Ink Tank
BCI-3eY
2
Insert the ink tank (label-side up) into the correct slot (refer to the color guide on
the printhead). Press down gently on the ink tank until an audible click is heard.
3
Repeat steps 1 and 2 to install the remaining magenta, cyan, and black ink tanks.
Correct position
4
Close the scanning unit until it locks into place.
Align the printhead as explained in step 9.

Align the printhead.

NOTE
• You can also align the printhead from the software.
For details, refer to the Software Guide.
When the LCD A displays the following, press [Set].
1
A L I G N P R I N T H E A D
P R E S S S E T K E Y
B
D C
• Make sure the ink tanks are inserted all
the way into their slots.
Incorrect position
NOTE
B
• To avoid spilling ink, never
press on the long sides of
the ink tank C.
• Once you remove the
protective cap B, do not
touch the ink port D.
IMPORTANT
NOTE
• If a display other than <ALIGN
PRINT HEAD> appears, refer to
A
p. 9-5 of the Quick Reference
Guide to align the printhead.