Canon MultiPASS F60 Comprehensive Manual page 116

Message (Error code)
NOT AVAILABLE
Fax Model
PROBLEM READING
CARD
PUT IN CARTRIDGE
REC'D IN
Fax Model
MEMORY
RECEIVED IN
Fax Model
FILE
Fax Model TRY AGAIN IN
B&W (#085)
TX nnnn
Fax Model
SCANNING P. nnn
MEMORY FULL
PLEASE WAIT
Fax Model TX/RX
CANCELLED
Fax Model TX/RX NO. nnnn
UNABLE TO PRINT ALL
WAIT COOLING
WASTED INK NEAR FULL
WRONG CARTRIDGE
Y INK EMPTY
Chapter 12
Cause
In manual sending, you entered a
speed dialing number that is
assigned to a group.
The data on the memory card
may be inaccessible.
There is no printhead installed in
the machine.
The machine received the fax in
memory because paper or ink
ran out, or a paper jam occurred.
Your computer was off and a
document was received in the
machine's memory.
The MultiPASS Status Monitor is
not running. (Windows 98/Me)
You tried sending a color
document to a machine that
does not support color faxing.
The machine is sending a
document and its memory is full.
You pressed [Stop/Reset] to
cancel the transmission.
When the machine sends or
receives a fax, it assigns it a
unique identification number
(nnnn).
In all frames photo printing, not
all the photographs were
printed.
During printing, the printhead
may have become too hot.
The waste ink tank is nearly full.
The printhead is not installed
correctly.
The yellow ink tank in the
printhead is empty.
Action
Use regular dialing, or enter a one-
touch speed dialing key or coded
speed dialing code that only has one
fax/telephone number registered.
Check the data on the memory card
in your digital camera.
Install the printhead.
Load paper in the multi-purpose tray,
replace the ink tank(s), or clear the
paper jam.
Upload the document to your
computer, or print the document.
Open the MultiPASS Status Monitor.
Try sending again in black & white.
Alternatively, enable the <COLOR
DIRECT TX> setting.
The machine continues to send the
document as memory becomes
available.
If required, try sending or receiving
again.
Write the number down if you will
need it later.
Check which photographs were not
printed and try reprinting them.
Allow the machine to cool down. The
machine will resume printing when it
has cooled down.
If <CHECK PRINTER> appears, contact
the Canon Customer Care Center.
Retry to install the printhead. If the
message remains in the LCD, the
printhead may be defective. Contact
the Canon Customer Care Center.
Replace the ink tank.
Troubleshooting
Details
Chapter 7
SS
p. 3-7
p. 11-4
p. 12-15
SG
SG
p. 13-4
Chapter 4
p. 11-4
12-21