Step 5: Install The Ink Tanks - Canon MultiPASS F50 Setup Instructions

Step 5: Install the Ink Tanks

1. Pull the orange tab off the yellow ink tank (BCI-3eY), then remove and discard
the plastic wrapper.
2. Twist off and discard the orange protective cap.
NOTE: To avoid spilling ink, never press on the sides of the ink tank.
3. Insert the ink tank into the correct slot (refer to the color guide on the printhead).
Press down gently until the ink tank locks into place.
4. Insert the remaining three ink tanks into their assigned slots.
5. Press the scanning unit closed until it clicks.