Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Installation
Installing the Leg Support Plate
(Optional on CGC Series Models)
WARNING - EXCESSIVE WEIGHT: When lifting
the brewer, at least two persons are required to
avoid personal injury.
WARNING: The water tank must be empty
before laying the brewer on its side.
For ease of installation, the brewer may be laid on its
side to allow access to the bottom. Lay the unit on a soft
padded surface to avoid scratches.
1
Remove the four legs from the bottom of the brewer
by unscrewing them. The front legs are different
from the rear legs. Note the location and difference
between the two types during removal.
2
Place the leg support plate on the bottom of the unit.
Line up the leg holes in the plate with the leg holes on
the bottom of the unit.
3
Reinstall the legs in the same positions they were
removed from in step 1.
Leveling
WARNING: Use the leveling legs to level the
brewer only. Do not use them to adjust brewer
height. Do not extend them higher than
necessary.
4
Position the unit on the countertop. Level it left to right
and front to back by turning the bottom of the legs.
Models CGC/CGC1: Setting the Brewer for 220-240
Volt Operation (Does not apply to CGCE/CGC1E)
5
Remove the screws that hold the back cover in place
and remove the cover.
6
Loosen the strain relief on the back of the brewer.
7
Disconnect the existing 120 Volt power cable from the
terminal block and remove.
8
Disconnect and cap the jumper wire between the "C"
and "N" terminals on the terminal block.
CGC, INSTALLATION INSTRUCTIONS
Back of brewer with
cover removed
Strain
relief
II13
Terminal
block
080820C
Advertisement
Table of Contents
