Table of Contents
Advertisement
All manuals and user guides at all-guides.com
3UREOHP
I want to enter a pause in a programmed
number to "wait for a dial tone".
I want to put in a new print cartridge but
the carriage went back over to the left.
I do not hear error beeps any more.
I ran out of ink and my printed faxes were
illegible or blank.
I cannot print faxes from memory.
It does not beep when I press each button.
No low ink warning.
Paper is not being picked up from the
paper tray.
Documents are not being picked up from
the document tray or more than one page
is being picked up at a time.
Maintenance and Troubleshooting
6ROXWLRQ
Use the Redial/Pause button to insert a
one second delay. The pause will display
as a - in your number.
Close and re-open both print cartridge
doors to get the carriage to come back
out.
The beep sounds have been turned off.
Turn on the beep sounds.
Replace the print cartridge and Reprint
Faxes from memory. Reprint faxes
immediately to avoid losing faxes in
memory.
Your fax may have lost power. A loss of
power causes faxes in memory to be lost.
Print the fax log to determine what faxes
were lost.
You are pressing the buttons faster than it
can register. Slow down.
The HP Fax does not monitor ink usage.
However, the cartridge is transparent
when empty. Remove the cartridge and to
visually see how much ink is left.
Media guides may be too tight. Squeeze
and adjust so they are just touching the
paper.
Remove and fan the paper then reload.
Make sure you open the door when
adding paper.
Media guides in document tray may be
too tight. Slide them so they are just
touching the paper.
Remove and fan the document pages then
reload.
Make sure the front panel door is
completely closed.
67
Advertisement
Table of Contents
