Shooting
Unable to shoot or
CF card is not loaded correctly.
➡
record images
CF card is full.
➡
The battery pack is out of power.
➡
Image out of focus (In-focus light in the viewfinder blinks).
➡
LCD monitor
Dust or foreign matter on the monitor.
➡
displays and
images are hard to
LCD monitor is worn out.
➡
see
Images are blurred
Lens focusing mode switch set to <MF> (or < M>).
➡
Camera shake when the shutter button is pressed.
➡
Unable to use the
CF card data is corrupted.
➡
CF card
➡
The message
The date/time battery is exhausted.
➡
"
" appears on
the LCD panel
Checking and Handling Images
Cannot erase
Images may be protected.
➡
images
Incorrect date and
Date/Time setting may be incorrect.
➡
time displayed
No image appears
Video cable plugs are not inserted fully.
➡
on the TV screen
The correct video format (NTSC or PAL) has not been set.
➡
Load the CF card correctly. (→28)
Change to a new CF card, or erase unwanted images. (→28, 43,
104)
Charge the battery pack. (→22)
Press the shutter button down halfway to focus again. If this fails,
focus manually. (→29, 59)
Clean the monitor with a soft eyeglass cloth.
Consult the store where you bought your camera, or a Canon
Service Center. (→10, back cover)
Set the focusing mode switch to < AF >. (→27)
Press the shutter button carefully so that the camera does not shake.
(→29, 36)
Format the CF card. (→105)
Use the specified type of CF card. (→2, 139)
Replace the battery with a new one. (→113)
Remove image protection. (→103)
Set date/time correctly. (→34)
Insert the video cable plugs firmly all the way. (→112)
Set the camera to the correct video format to match the TV set.
(→112)
REFERENCE
7
137