Table of Contents
Advertisement
External Engine Components
G
F
A
Dipstick
E
Oil Drain Plug
I
Oil Fill Cap
Install Starter Plate and Starter Assembly
1. Install starter plate to crankcase. Install mounting
screws and torque screws to 15.3 N·m (135 in. lb.).
2. Mount starter to adapter plate using screws.
3. Make sure starter is square to fl ywheel, and torque
screws to 15.3 N·m (135 in. lb.).
4. Attach leads to appropriate starter solenoid
terminals.
Connect Oxygen Sensor
1. If oxygen sensor was removed from muffl er (OEM
supplied), reinstall it and torque to 18 N·m (159 in.
lb.).
2. Connect oxygen sensor to wire harness.
66 690 14 Rev. A
H
B
Spark Plug Lead
F
Radiator Drain Plug
KohlerEngines.com
A
I
B
D
E
C
C
Electric Starter
G
Oil Filter
Install Oil Filter and Fill Crankcase with Oil
NOTE: Make sure both oil drain plugs are installed and
torqued to specifi cations to prevent oil leakage.
1. Install oil drain plug(s). Torque plug(s) to 13.6 N·m
(10 ft. lb.). If oil drain valve is used, make sure valve
body is closed and cap is on.
2. Place new fi lter in shallow pan with open end up. Fill
with new oil until oil reaches bottom of threads. Allow
2 minutes for oil to be absorbed by fi lter material.
3. Apply a thin fi lm of clean oil to rubber gasket on oil
fi lter.
4. Refer to instructions on oil fi lter for proper
installation.
5. Fill crankcase with new oil. Level should be at top of
indicator on dipstick.
6. Reinstall oil fi ll cap/dipstick and tighten securely.
Reassembly
D
Starter Plate
H
Radiator Cap
101
Advertisement
Table of Contents
