MSI KM4M Series Manual page 59

MS-6734 M-ATX Mainboard
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) installed
on the system board and you wish to use it. If you install add-on FDC or
the system has no floppy drive, select Disabled in this field. The settings
are: Enabled and Disabled.
Onboard Serial Port 1
Select an address and corresponding interrupt for the first serial port. The
settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
directional transmission/reception is allowed. Under Half Duplex mode,
only asynchronous, bi-directional transmission/reception is allowed.
Onboard Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that
provides Standard, ECP, and EPP features. It has the following options:
Disabled
3BC/IRQ7
278/IRQ5
378/IRQ7
Parallel Port Mode
SPP : Standard Parallel Port
EPP : Enhanced Parallel Port
ECP : Extended Capability Port
ECP + EPP: Extended Capability Port + Enhanced Parallel Port
SPP/EPP/ECP/ECP+EPP
To operate the onboard parallel port as Standard Parallel Port
only, choose "SPP." To operate the onboard parallel port in the
EPP mode simultaneously, choose "EPP." By choosing "ECP",
the onboard parallel port will operate in ECP mode only. Choosing
"ECP + EPP" will allow the onboard parallel port to support both
the ECP and EPP modes simultaneously.
EPP Mode Select
The onboard parallel port is EPP Spec. compliant, so after the user chooses
the onboard parallel port with the EPP function, the following message
will be displayed on the screen: "EPP Mode Select." At this time either
EPP 1.7 spec or EPP 1.9 spec can be chosen.
3-18
Line Printer port 0
Line Printer port 2
Line Printer port 1