Brother P-touch 2300 User Manual page 67

Error Message
NO This message appears if you try to print
TAPE! a label or feed the tape when no tape
cassette is installed.
REPLACE This message appears if the installed
BATTERIES! alkaline batteries are about to run
out.
ROM This message appears if there is a
PROBLEM! problem with the machine's read
only memory.
SOLDER X This message appears if there is a
problem with the machine's software.
TAB This message appears if 50 tabs have
LIMIT! already been added to the text when
you press Q.
TEXT This message appears if the size of
TOO HIGH! the text is larger than the width of the
installed tape.
TEXT This message appears if the length of
TOO LONG! the text is longer than the label length
that has been set using the Length
function.
Cause Remedy
Install a tape cassette and try
again.
Replace the batteries or use the
AC adaptor.
Contact your service representa-
tive.
Turn off the machine, and then
while holding down c and
R, turn the machine back on.
Contact your service representa-
tive.
Limit the number of tabs in the
text to 50.
Reduce the size of the characters
or install a wider tape.
Delete some of the text, reduce
the character width or increase
the set label length.
63