Operation In Salt Water - Suzuki DF150AP Owner's Manual

Setting the Troll Mode
1. Shift into forward or reverse gear and make
sure that the throttle is fully closed (in-gear
idle speed).
2. Press the "UP" or "DN" position of the troll
mode switch, until you hear one beep. At the
same time, the
switches over to the TROLL Mode specific
screen and
gauge screen. When the gauge screen dis-
plays "Engine Speed Screen" or "All Items
Screen", the engine speed screen automati-
cally changes from an analog to a digital dis-
play.
NOTE:
• This system will not function properly until
engine is at normal operating temperature.
• If the switch is pressed and held while the
remote control lever is set to neutral, the
mode will not switch to TROLL Mode.
• For the multiple engines:
When the switch is pressed and held while
–
all the engine throttles are fully closed and
the clutch is engaged in only one of the
engines, the mode will switch to TROLL
mode.
In-gear idle speed of all engines is con-
–
trolled at the same time.
76
Multi-Function Screen
is displayed on the
Adjusting Trolling Speed
• When pressing the "UP" switch, one short
beep sounds and
increases by 50 r/min.
• When pressing the "DN" switch, one short
beep sounds and
decreases by 50 r/min.
NOTE:
• When pressing the "DN" switch at the lower
limit of trolling speed of all engines, the
engine speed will not change and three long
beeps will sound.
• When pressing the "UP" switch at the upper
limit of trolling speed of all engines, the
engine speed will not change and three long
beeps will sound.
• For the multiple engines:
If the switch is operated when one engine
has reached the adjustment limit of trolling
speed, while any other engine has not, one
short beep sounds and the rpm of engine
which has not reached the adjustment limit
changes.
• Shift operation and throttle control remain
operational, even in troll mode.
Cancelling the Troll mode:
The troll mode can be cancelled by shifting the
all remote control levers to the neutral position,
or by increasing the engine speed to 3000 r/min
or more. In both cases, two short beeps sound
when cancelling the troll mode.

OPERATION IN SALT WATER

After operating the motor in salt water, you
should flush the water passages with clean,
fresh water as outlined in the FLUSHING THE
WATER PASSAGES section. If you do not flush
the water passages, salt can corrode the motor
and shorten its life.
the engine speed
the engine speed