Tcp/Ip Configuration Status; Wireless; Basic Settings - CNET CWA-854 User Manual

2.2.3 TCP/IP Configuration status

This TCP/IP Configuration status includes:
Attain IP Protocol, IP Address, Subnet Mask, Default Gateway, and MAC Address.

2.3 Wireless

2.3.1 Basic Settings

The wireless basic settings include Band, Mode, SSID and Channel Number.
Disable Wireless LAN Interface: check or uncheck (Enable or Disable).
-
- Band: This Wireless Access Point can support three RF band: 802.11B/G,
802.11G and 802.11B.
Mode: This Wireless Access Point supports four operating modes: AP, client,
-
WDS, and AP+WDS.
Network Type: when operating mode is Client mode, users can select the
-
network type as "Infrastructure" or "Adhoc" mode.
SSID: The SSID differentiates one WLAN from another, therefore, all wireless
-
access points/routers and all wireless devices attempting to connect to a
specific WLAN must use the same SSID. It is case-sensitive and must not
exceed 32 characters.
- Channel Number: The number of channels supported depends on the region of
this Wireless Access Point. All stations communicating with this Wireless
Access Point must use the same channel.
Associated Clients: When you click the "Show Active Client" button, it will show
-
all the clients already associating this Wireless Access Point, see the "Active
Wireless Client Table", only valid for AP mode and AP+WDS mode.
Enable Mac clone: when operating mode is Client mode and only one Ethernet
-
client exists, users can enable this Mac clone feature to connect with wireless
station easily.