Access Point Configuration; Hardware Installation; Software Installation - CNET CNAP-711 User Manual

3 Access Point Configuration

3.1 Hardware installation

Connect the LAN RJ45 port of the Access Point (AP) to a PC, Notebook or User existing
network (using Ethernet Cat. 5 cable) and connect the DC power adaptor to the AP.
Note: To configure the AP, User can use either the wired Ethernet connection or a Wireless
LAN device.

3.2 Software installation

Insert the setup CD into the CD-ROM drive of the PC or Notebook used for configuration.
There are two methods to install the AP utility software:
(a). Auto run: an auto run program will display on the screen. Click "Install Software"
(b). Alternately, please click "start\run\D:\AP\utility\setup.exe (D:\ is the default letter for the
CD-ROM drive). The InstallShield Wizard will guide User through the installation in the
following menu sequence:
7