Table of Contents
Advertisement
Installation
I
INSTALLATION
Selection of Installation Location
SELECTION OF INSTALLATION LOCATION (Fig.3)
Place the portable air conditioner in a flat location where the air inlets and outlets cannot be covered up. Place the unit no less
than 50cm away from a wall or other obstacle. In addition a minimum 50cm clearance is required from all faces of the air
conditioner including the rear face.
50cm clearance required for air inlet.
The appliance must be installed, used and stored in a ventilated area that is greater than 9m
ASSEMBLY OF EXHAUST HOSE, HOSE INLET, HOSE OUTLET AND WINDOW SLIDER
Assembly of Exhaust Hose, Hose Inlet, Hose Outlet and Window Slider
•
Fully extend each end of the exhaust hose by about 10cm and attach the hose inlet and hose outlet to opposite ends by
rotating the inlet/outlet in a counter clockwise direction approximately 3 to 4 turns, making sure that the hose wire is
well threaded into the hose inlet and outlet. The hose inlet and outlet cannot be installed unless the hose ends have been
fully extended.
•
Clip the hose outlet into the window slider. Take care to not break the tabs on the hose outlet when disconnecting from
the window slider.
0
window
slider
Page 16
I
�
hose
outlet
0
50cm clearance at back to
/ allow for air outlet hose.
Fig. 3
hose
5
hose
inlet
.
2
Advertisement
Table of Contents
