Table of Contents
Advertisement
Chapter 3 Install Your Broadband Router
3.1 Connect Client PC to Broadband Router
Use an Ethernet cable to connect your client PC to Broadband Router's local LAN
port.
Broadband Router supports auto-crossover, so you can use either a
Straight- Through cable or a Crossover cable to connect the client PC to
the LAN port.
3.2 Connect Ethernet Hub/Switch to Broadband Router
If you have more than four clients, connect a hub or switch to any of the Broadband
Router's LAN ports with an Ethernet cable, then connect each client PC to the hub or
switch with an Ethernet cable as
3.3 Connect Wireless Access Point to Broadband Router
You can extend the wired LAN by connecting Wireless Access Point to Broadband
Router 's LAN port. Then a wireless network will be set up and it will turn into an
infrastructure mode. The whole network coverage will be expanded by Access Point
wireless connection to the wireless clients.
3.4 Connect Cable/xDSL Modem to Broadband Router
Use the Ethernet cable to connect a Cable Modem or xDSL Box to Broadband
Router 's Internet WAN port.
3.5 Power up Broadband Router
Connect the correct Power Adapter to Broadband Router. Then plug the Power
Adapter into an AC power outlet. The LED status will be as followed.
1.
Power LED and the 4 LAN port's LED will turn on for the first second.
2.
The Power LED will be continuously on when the power is supplied. It takes
around 15 seconds to boot.
3.
The WAN and LAN link/act LED will be continuously on when Broadband
Router is connected to the WAN and the LAN. The link/act LED will be
well.
11
Advertisement
Table of Contents
