List Of Factory Settings - Brother HL-2400C Series User Manual

4. Press the Set button to make the displayed selection effective.
The printer is reset according to the selected reset mode.
Selected Mode
RESET PRINTER
RESET SETTING 1-2
FACTORY SETTINGS
1* - # indicates the selected number of saved settings
The printer automatically exits from the reset mode to the on-line
state.
5. When you enter the RESET PARTS LIFE mode;
LCD Message on the lower row
FC ROLLER
OPC BELT
FUSER UNIT
120K KIT
The reset item is selected according to the Maintenance message that
shows the currently recommended maintenance part to replace. Press
Set to reset the parts life.

List of Factory Settings

The following table shows the factory settings made before shipment.
Notes

The settings are subject to the emulation mode. Effective modes are
indicated in parentheses in the following table.

The following settings cannot be restored to the factory settings with
the Reset button in the "FACTORY SETTINGS" mode:
INTERFACE MODE, HRC SETTING, PAGE PROTECTION,
SCALABLE FONT, LOCK PANEL, and PAGE COUNTER, and
local language for display messages.

The COPY setting is always restored to the factory setting when the
printer is turned off and on again.

The user settings are overwritten after resetting to setting 1 or 2.
CHAPTER 4 CONTROL PANEL
LCD message on the upper row

08 RESET TO USER SETTINGS

08 RESET TO SETTING # 1*

09 RESET TO FACTORY
SETTINGS
Parts replaced
Fuser Cleaner
(OPC) Belt Cartridge
Fixing Unit
Drum Cleaner, Paper discharger,
Transfer Roller
4–69