Treatment Of Submerged Motor - Yamaha F200 Owner's Manual

1. Water detection switch coupler
4. Remove the filter cup from the filter
housing, and then remove the O-ring
from the filter cup. NOTICE: Be careful
not to twist the water detection switch
lead when unscrewing the filter cup.
[ECM01961]
4
1. Filter housing
2. O-ring
3. Filter cup
4. Water detection switch lead
5. Drain the water in the filter cup by soak-
ing it up with a rag.
6. Put the O-ring on the filter cup in its orig-
inal position, and then install the filter cup
onto the filter housing. NOTICE: Be
careful not to twist the water detec-
tion switch lead when screwing the fil-
ter cup onto the filter housing.
1
ZMU07789
1
2
3
ZMU07790
[ECM01971]
Trouble Recovery
1
2
3
1. O-ring
2. Filter cup
3. Water detection switch lead
7. Connect the water detection switch cou-
pler securely until a click is heard.
8. Install the top cowling.
9. Turn the main switch to the "
sition and check that the water separa-
tor-alert indicator remains off and the
buzzer does not sound. If the water sep-
arator-alert indicator blinks or the buzzer
sounds, have your Yamaha dealer check
the outboard motor. NOTICE: Although
the buzzer will stop when the engine is
started and the control lever is moved
to the forward or reverse position, do
not use the outboard motor. Other-
wise, serious engine damage could
occur.
[ECM02481]
EMU33502

Treatment of submerged motor

If the outboard motor is submerged, immedi-
ately take it to a Yamaha dealer. Otherwise
some corrosion may begin almost immedi-
ately. NOTICE: Do not attempt to run the
outboard motor until it has been com-
pletely inspected.
[ECM00402]
ZMU07791
" (on) po-
100