Table of Contents
Advertisement
User's Manual
INSTALLATION INSTRUCTIONS
INSTALL &
REMOVE
Figure.1. Installing and Removing the Base
Put machine flat on working table. Install base in machine bottom of back cover as arrow direction,
and make the positioning hole on top of V cover of base aligned with the positioning raised stand on
the bottom of machine back cover, then fasten screw.(The base has to be adjusted to figure state,
otherwise base cannot be installed in.)
Remark: The actual base and machine appearance may be different from pictures; please refer to the
actual device.
POWER
POWER SOURCE:
1. Make sure that the power cord is the correct type required in your area.
2. This LCD monitor has an Internal universal power supply that allows operation in either
100/120V AC or 220/240V AC voltage area (No user adjustment is required.)
8
Advertisement
Table of Contents
