GI -22
8.
When disconnecting a connector, be sure to grip only
the connector, not the wires.
9.
Disconnect connector which have catches by press-
ing in the direction of the arrows shown the illustration.
10. Connect connectors which have catches by inserting
the connectors until they make a clicking sound.
EAKE006C
11. When using a circuit tester to check continuity or volt-
age on connector terminals, insert the test probe into
the harness side. If the connector is a sealed con-
nector, insert the test probe through the hole in the
rubber cap until contacts the terminal, being careful
not to damage the insulation of the wires.
Test probe
EAKE006D
GENERAL INFORMATION
Test probe
Connector
EAKE006E
EAKE006G