Kia RIO 2005 General Information Manual page 12

GI -12
TIGHTENING TORQUE TABLE OF STANDARD
PARTS
Bolt nominal
diameter (mm)
EAKE004E
M5
M6
M8
M10
M12
M14
M16
M18
M20
M22
M24
NOTE
1. The torques shown in the table are standard val-
ues under the following conditions :
• Nuts and bolts are made of galvanized steel
bar.
• Galvanized plain steel washers are inserted.
• All nuts, bolts and plain washers are dry.
2. The torques shown in the table are not applica-
ble:
• When spring washers, toothed washers and
the like are inserted.
• If plastic parts are fastened.
• If self-tapping screws or self-locking nuts are
used.
• If threads and surfaces are coated with oil.
3. If you reduce the torques in the table to the per-
centage indicated below, under the following con-
ditions, if will be the standard value.
• If spring washers are used : 85%
• If threads and bearing sufaces are stained
with oil : 85%
Pitch (mm)
KASD100Y
0.8 3 ~ 4 (30 ~ 40, 2.2 ~ 2.9)
1.0 5 ~ 6 (50 ~ 60, 3.6 ~ 4.3)
1.25
12 ~ 15 (120 ~ 150, 9 ~ 11)
1.25
25 ~ 30 (250 ~ 300, 18 ~ 22)
1.25
35 ~ 45 (350 ~ 450, 25 ~ 33)
1.5 75 ~ 85 (750 ~ 850, 54 ~ 61)
1.5 110 ~ 130 (1,100 ~ 1,300, 80 ~ 94)
1.5 160 ~ 180 (1,600 ~ 1,800, 116 ~ 130) 260 ~ 300 (2,600 ~ 3,000, 190 ~ 215)
1.5 220 ~ 250 (2,200 ~ 2,500, 160 ~ 180) 360 ~ 420 (3,600 ~ 4,200, 260 ~ 300)
1.5
290 ~ 330 (2,900 ~ 3,300, 210 ~ 240) 480 ~ 550 (4,800 ~ 5,500, 350 ~ 400)
1.5
360 ~ 420 (3,600 ~ 4,200, 260 ~ 300) 610 ~ 700 (6,100 ~ 7,000, 440 ~ 505)
Torque Nm (kg.cm, lb.ft)
Head Mark 4
EAKE004F
GENERAL INFORMATION
Head Mark 7
5 ~ 6 (50 ~ 60, 3.6 ~ 4.3)
9 ~ 11 (90 ~ 110, 6.5 ~ 8.0)
20 ~ 25 (200 ~ 250, 14.5 ~ 18.0 )
30 ~ 50 (300 ~ 500, 22 ~ 36)
60 ~ 80 (600 ~ 800, 43 ~ 58)
120 ~ 140 (1,200 ~ 1,400, 85 ~ 100)
180 ~ 210 (1,800 ~ 2,100, 130 ~ 150)
EAKE004G