Projection Distance; Adjusting The Projection Angle Using The Ball Joint; G G Related Links; Projector Placement - Epson EV-110 User Manual

Projector Placement

Installation space (When installing multiple projectors side by side)
Attention
If you are installing multiple projectors next to each other, make sure hot air from
the exhaust vent does not go into the air intake vent of another projector.
50 cm
A

g g Related Links

• "Screen Size and Projection Distance"

Projection Distance

The distance at which you place the projector from the screen determines the
approximate size of the image. The image size increases the farther the
projector is from the screen, but can vary depending on the zoom factor,
aspect ratio, and other settings.
See the Appendix for details about how far to place the projector from the
screen based on the size of the projected image.
p.163
When correcting keystone distortion, your image is slightly smaller.
a
g g Related Links
• "Screen Size and Projection Distance"

Adjusting the Projection Angle Using the Ball Joint

You can adjust the projection angle using the ball joint.
Caution
• Make sure you do not trap your fingers in the ball joint.
• Do not force the projection unit to move after tightening the ball joint screw.
Attention
Make sure you support the bottom of the projection unit so that it does not move,
and tighten the screw with the hexagonal wrench supplied (diagonal size 5.0 mm).
p.163
21