Copying Menu Settings Between Projectors (Batch Setup); Transferring Settings From An Sd Card - Epson EV-110 User Manual

Copying Menu Settings Between Projectors (Batch Setup)

After selecting the projector's menu settings for one projector, you can use the
following methods to copy the settings to other projectors, as long as they are
the same model.
• by using an SD card
• by using Epson Projector Management
• Perform batch setup before adjusting the image settings such as
keystone distortion correction. Since image adjustment values are
also copied to another projector, the adjustments you made before
a
performing the batch setup are overwritten and the projected screen
you adjusted may change.
• When copying the menu settings from one projector to another,
user's logo is also copied. Do not register the information that you do
not want to share between multiple projectors as a user's logo.
• Make sure Batch Setup Range is set to Limited if you do not want to
copy the following settings:
• Password Protection settings
• Network menu settings (except for the Notifications menu and
the Others menu)
s Extended > Operation > Advanced > Batch Setup Range
Caution
Epson takes no responsibility for batch setup failures and associated repair costs
due to power outages, communication errors, or other problems that may cause
such failures.
g g Related Links
• "Transferring Settings From an SD Card"

Transferring Settings From an SD Card

You can copy menu settings from one projector to another of the same model
using an SD card.
p.140
• Connect an empty SD card. If the SD card contains data other than
the batch setup file, the settings may not be saved correctly.
a
• If you have saved a batch setup file from another projector to the SD
card, delete the file or change the file name. The batch setup function
cannot overwrite a batch setup file.
a Disconnect the power cord from the projector, and check that all of the
projector's indicators have turned off.
b Insert an empty SD card directly to the projector's SD card slot.
c Hold down the [Esc] button on the remote control and connect the
power cord to the projector.
d
When all of the projector's indicators other than the Wireless LAN
indicator turn on, release the [Esc] button.
The indicators start flashing and the batch setup file is written to the SD
card. When writing is finished, the projector turns off.
Caution
Do not disconnect the power cord or the SD card from the projector while
the file is being written. If the power cord or SD card is disconnected, the
projector may not start correctly.
e Remove the SD card.
The file name for the batch setup file is PJCONFDATA.bin. If
you need to change the file name, add text after PJCONFDATA
using only alphanumeric characters. If you change the
a
PJCONFDATA section of the file name, the projector may not be
able to recognize the file correctly.
f Disconnect the power cord from the projector to which you want to
copy settings, and check that all of the projector's indicators have
turned off.
140