Security Button - Planet Networking & Communication PL-702 User Manual

The lower panel contains a history of all remote devices.
Devices are shown here regardless of whether or not they are on the same logical
network.
Device Name
MAC Address
Password
Rate(Tx/Rx)
Network
Last Seen
Last Known Network
Chipset manufacturer name (Turbo Only devices)
Date device last scanned

3.5 Security Button

This section describes how to use Security button for configuration in the following
situations:
Establish a new security network (Network AB)
The procedure is as follows:
Step 1
Press and hold the Security button on Bridge A for no more than 10
seconds. Must release after 10 seconds. Once released, the Power light will
flash. The password to Bridge A has just been erased and random security key
has been generated. It must now be linked to your network to adopt the new
network security key.
Step 2
Press and hold the security button on Bridge B for 10 seconds and
release it when the Power light flashes. The password to Bridge B has just been
User's Manual of PL-702
24