Presser Foot Lever - Brother Innov-is 40 Operation Manual

GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
p Raise the presser foot lever, pass the end of
the thread through the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
a 5 cm (2 inches)
The upper threading is finished.
■ Manually threading the needle
If the needle threader cannot be used, thread the
needle as described below.
a Thread the machine to the needle bar thread
guide, as described in steps
"Threading the upper thread", and then lower
the presser foot lever.
b Turn off the sewing machine.
CAUTION
● Be sure to turn off the sewing machine,
otherwise injuries may occur if the start/stop
button is accidentally pressed and the
machine starts sewing.
c Manually pass the thread through the eye of
the needle from front to back.
24
d
a
e
a k
through of
Raise the presser foot lever.
a
a Presser foot lever
Pass the end of the thread through the presser
foot, and then pull out about 5 cm (2 inches)
of thread toward the rear of the machine.
a 5 cm (2 inches)
a