Brother CS-8060 Operation Manual page 42

GETTING READY ———————————————————————————————————————————————————
4 Press the black button at the back of the
presser foot holder.
1
2
1 Black button
2 Presser foot holder
The presser foot holder releases the presser
foot.
5 Place a different presser foot below the holder
so that the presser foot pin is aligned with the
notch in the holder.
Position the presser foot so the letter indicating
the presser foot type (A, G, I, J, M, N or R) is
positioned to be read.
1
2
1 Presser foot holder
2 Notch
3 Pin
6 Slowly lower the presser foot lever so that the
presser foot pin snaps into the notch in the
presser foot holder.
1
1 Presser foot lever
The presser foot is attached.
36
7
3
Raise the presser foot lever to check that the
presser foot is securely attached.
Note
● For details on the presser foot that should be
used with the selected stitch, refer to "Stitch
Settings" (page 96).